This is just the C channel section in the middle of your truck under the cab, if you need the boxed section as well please see my other listings.
Is your 1996-2002 second gen frame rotted? Finally a solution. This is the section right in front of the front leaf perch in rear of the truck. Its a "C channel" section that commonly rust out and leave your frame unrepairable. There are no other options out there. I finally decided to break out fusion 360 and create a solution.
Made of 3/16" mild steel. These will come bare steel NO PAINT. You will have to grind the mill scale coating off where your going to weld, its on there to prevent rust while it sits on the shelf.
They will be shipped flat to you with instructions easily explaining what needs to be done with pictures included. THIS FITS DRIVER SIDE ONLY. You will need to grind your frame minimally to get the best fit possible.
WELDING KNOWLEDGE AND WELDER NEEDED FOR THIS JOB. Seems obvious but it needs to be said. Please follow the instructions properly and it will come out awesome.
All pieces designed on fusion 360 and have gone through multiple revisions to be perfect, and then they were cut on a plasma table for precise cuts. This will fit perfectly on a EXTENDED cab long bed. Hoping to save some dodge frames out there and an easy solution for welders to get a job done quick and easy.
Fits perfectly on Extended cab long bed 2500/3500. They have not been tested on ext cab short bed trucks OR 1500 trucks.
